|
Post by NightMachines on Dec 21, 2019 12:09:11 GMT
Super super beginner question here, but how do you split the 5v power source from the Arduino to multiple power sources when soldering? It's obvious on a breadboard but I'm not sure how to go about this on one of the PCB prototyping boards Not sure if I understand your question. It's the same as on the breadboard. You just wire the 5V source to the destinations.
|
|
|
Post by despairbear on Dec 22, 2019 9:54:32 GMT
So am I able to just split the wire? Sorry, totally new to the electrical side of this. On the breadboard there's a strip I can connect to to distribute the power, on the PCB prototyping board there is not so I'm just not sure how to go about this.
Also a side question, what do you use to cut the blank AE modular panels for your DIY ones?
|
|
|
Post by NightMachines on Dec 22, 2019 10:53:00 GMT
So am I able to just split the wire? Sorry, totally new to the electrical side of this. On the breadboard there's a strip I can connect to to distribute the power, on the PCB prototyping board there is not so I'm just not sure how to go about this. Also a side question, what do you use to cut the blank AE modular panels for your DIY ones? The strip on the bread board is just a metal rail, so it’s the same as splitting a wire connection For cutting I use a fine bladed fretsaw (the U shaped kind with the thin blades). You can also use a sharp knife to cut a groove into the board and then break it off cleanly over an edge (like a stair step or sturdy window sill).
|
|
|
Post by NightMachines on Apr 7, 2020 9:39:09 GMT
|
|
thundersound
Junior Member
A modular world .. from Aa to Thunder and beyond
Posts: 82
|
Post by thundersound on Apr 7, 2020 11:44:43 GMT
It thunders well and sounds great ))
|
|
|
Post by funbun on Apr 8, 2020 20:03:06 GMT
Sweet! Will Robert produce these or you?
|
|
|
Post by NightMachines on Apr 8, 2020 20:34:04 GMT
Sweet! Will Robert produce these or you? Thanks! I don’t think it will be properly produced. I would certainly need some alterations. Wouldn’t be hard, but I think you could do a version of this with the GRAINS already. I’ll see that I’ll get the GRAINS at some point and do some coding for it
|
|