Lugia
Wiki Editors
Ridiculously busy...ish.
Posts: 556 
|
Post by Lugia on May 2, 2020 1:06:29 GMT
OK...about ready to add the spring tanks for my reverbs. Gargantua has two spring modules, with the idea there being that I can use two different tanks to get different frequency/time responses. While most tanks appear to have between 2k to 2.5kOhm on their outputs, the input impedance for tanks from Accutronics, Mod, et al vary considerably. So, what impedance loading should I have on the tank inputs to get optimal results with the AE module?
|
|
|
|
Post by lukylutte on May 3, 2020 8:48:12 GMT
Sorry I cannot help you on this. But I have a question about the reverb tank. I didn’t took the Ae modular one as I haves couple at home. However the wet signal is really weak (not the noise when I touch the spring). I have the Belton BMN3AB3B1B. I have no idea what it is nor the ae modular one (could only find its size...). If I put full wet it’s so low that you barely ear anything... Is it normal? Is it the wrong spec or something?
Could it be some impedance problem?
|
|
Lugia
Wiki Editors
Ridiculously busy...ish.
Posts: 556
|
Post by Lugia on May 4, 2020 2:26:55 GMT
|
|
