|
|
Post by factorypreset on Nov 20, 2020 7:45:28 GMT
Hello
I am trying out Project 1 on the Braedboard. In the photograph on the Project page the pots appear to be connected to a board.what is this board please. I have tried to place them on the breadboard by bending the lugs back, it works but not very well. Thank you.
|
|
|
|
Post by admin on Nov 20, 2020 9:29:43 GMT
When you buy the BRAEDBPARD module you get two pots soldered onto a tiny PCB with legs that fit into the breadboard. That's what's used in the Project on the Wiki. See this photo on the product page:  www.tangiblewaves.com/store/p92/BRAEDBOARD.html |
|
|
|
Post by factorypreset on Nov 20, 2020 10:21:29 GMT
Thank you for your reply. The pots in my kit are separate, not on a board. Can I oder them on a board please.
|
|
|
|
Post by admin on Nov 22, 2020 7:59:24 GMT
Thank you for your reply. The pots in my kit are separate, not on a board. Can I oder them on a board please. Could you please send an email to Robert at tangiblewaves@gmail.com? If you bought it from the tangiblewaves.com website and it didn't come with the potis on the board, then Robert will most likely send that part to you. |
|
|
|
Post by factorypreset on Nov 28, 2020 10:16:22 GMT
Hi did that but have had no response, I have just sent a second email.
Steve
|
|
|
|
Post by robertlanger on Nov 28, 2020 21:20:46 GMT
Was our fault with packing; sorry. I will send the pots boards to you!
|
|
