|
|
Post by saltatempo on Oct 6, 2024 12:32:05 GMT
Hi people, I did some experiments with an oscilloscope and I'd like to share the data.
The Volca and the VM-BRIDGE parts used
Yellow probe at SYNC I/O ---> always Vpp = 0-5 V ; spike
Green probe at main gate of Volca ---> Vpp = 0-3,3 V ; inverted spike
Blue probe at CV2 of VMBRIDGE ---> Vpp = 0-5 V ; inverted spike
With parameter "Tempo range settings" between 56 and 240 Clock at 56 means 275 ms ---> f = 3,6 Hz
Clock in the middle means 125 ms ---> f = 8 Hz
Clock at 240 means 75 ms ---> f = 13,3 Hz (measured by the scope is better and is f = 16 Hz)
Here we can see that is ok putting the green probe at /2 , /3 , /4 gates
|
|
|
|
Post by saltatempo on Oct 6, 2024 12:38:14 GMT
Now we modify the "Tempo range settings" to have full range 10-600 and here are the data.
Clock at 10 means 1500 ms ---> f = 0,67 Hz (very low  )
Clock in the middle range means 167 ms ---> f = 6 Hz
Finally clock at 600 means 25 ms ---> f = 40 Hz (audio range...)
Hope useful.
Clear skies with your sound
|
|
|
|
Post by keurslagerkurt on Oct 7, 2024 9:26:35 GMT
So, that's looking good right?
Also, i'm curious what you are using the small copper (?) wires for, the wires that are squeezed in with the cables.
|
|
|
|
Post by saltatempo on Oct 7, 2024 13:56:41 GMT
I'm trying to deal with old jumper too tiny in their section and new holes too big for them...
|
|
|
|
Post by saltatempo on Oct 7, 2024 13:58:06 GMT
In future I think I'll buy new patchwires, golden ones bigger in their section...
Nevertheless Volca modular uses old tiny jumper
|
|
)
