|
|
Post by spacedog on Sept 27, 2019 13:38:56 GMT
You can also use the old trick of mixing gate signals at different intensities, for example with an ATTMIX in DC mode. Patch the TOPOGRAF’s (or any other gate sequencer’s) gate outputs into the mixer and the mix output into a VCO‘s pitch input. Then you can tune each gate signal channel by turning down the according mixer knob. If two or more gates are high at the same time, they will add, creating a new pitch CV. Mmmm, my experience of mixing CVs, especially for use in pitch, has not been great. I wrote about it in one of the patch challenges. Being unbuffered, the voltages get pulled every which way. I should build some buffers, I guess  My point is that the results can be unpredictable, which is not always a bad thing, unless it's pitch... Sometimes then as well, I suppose. |
|
|
|
Post by admin on Sept 28, 2019 1:27:53 GMT
So I finally managed to edit and upload my first basic introduction video for the TOPOGRAF:
|
|
Lugia
Wiki Editors
Ridiculously busy...ish.
Posts: 556 
|
Post by Lugia on Sept 28, 2019 22:18:51 GMT
Mmmm, my experience of mixing CVs, especially for use in pitch, has not been great. I wrote about it in one of the patch challenges. Being unbuffered, the voltages get pulled every which way. I should build some buffers, I guess My point is that the results can be unpredictable, which is not always a bad thing, unless it's pitch... Sometimes then as well, I suppose. Wait until Robert gets the quantizers done...this should inject a lot more predictability into manipulating pitch CVs. |
|
|
|
Post by loopier on Sept 29, 2019 6:51:56 GMT
You can also use the old trick of mixing gate signals at different intensities, for example with an ATTMIX in DC mode. Patch the TOPOGRAF’s (or any other gate sequencer’s) gate outputs into the mixer and the mix output into a VCO‘s pitch input. Then you can tune each gate signal channel by turning down the according mixer knob. If two or more gates are high at the same time, they will add, creating a new pitch CV. Oh! What a great idea to add voltages for melodies! Thanks! |
|
|
|
Post by admin on Oct 7, 2019 13:31:17 GMT
Here is the second video about the TOPOGRAF ... advanced configuration options:
|
|
pol
Wiki Editors
Posts: 1,349
|
Post by pol on Oct 8, 2019 21:18:50 GMT
Wow now i really can't wait for my topograf to arrive. Thanks for all the ideas. Same here! |
|
|
|
Post by lukylutte on Oct 9, 2019 4:54:48 GMT
I was thinking to buy a second one for only melodies. But that will happen only when I'll need a extension case (as soon as the Solina will appear on the shop). With the help of the Logic stuff can already get some nice interconnected lines...
|
|
|
|
Post by duddex on Feb 5, 2022 10:02:36 GMT
The Topograf has the exact same program as MI Grids - but is it also possible to write alternate firmware as shown in this video? Especially: is Topograf compatible with this ATMEL Programmer used in the video? |
|
