|
|
Post by rodney on Nov 16, 2019 7:40:53 GMT
So, I decided to pollute my pure AE rack with my Teenage Engineering PO32 drum thingamajig.
It is a little wider than 2 modules so I sacrificed three spaces. However, depending on the neighboring ones, two might do it.
I took out the blank panels and added two wide rubber bands to hold the OP32 in place near the Master module so I can sync it to an LFO. I had no luck getting the AE's sequencers to sync to the PO32's sync out though, so I'll have to do a bit of homework to find out why (any clues peeps?).
Okay, not rocket science but sometimes these simple methods don't occur to me until I've already started cutting holes in stuff then changed my mind. 
|
|
|
|
Post by slowscape on Nov 16, 2019 23:31:33 GMT
lol actually doesn't look half bad!
|
|
|
|
Post by NightMachines on Nov 17, 2019 8:30:07 GMT
I had no luck getting the AE's sequencers to sync to the PO32's sync out though, so I'll have to do a bit of homework to find out why (any clues peeps?) Nice job with the red rubber bands! Regarding sync, I never used a PO, but looking at the manual you should set sync mode to SY1, SY3 or SY5. Those will output sync pulses on the tip/left channel and mono audio on the ring/right channel. Plug the 3.5mm stereo TRS cable from the PO’s output into the 4I/O module’s 3.5 mm socket 1 and then get sync from the 1 I/O and audio from the 2 I/O pin header sockets. If you don’t have the 4I/O you need a 3.5mm TRS stereo to left/right TS mono Y cable to split the sync and audio to two separat 3.5 mm jacks. Then you can use the Master I/O sockets. |
|
|
|
Post by rodney on Nov 25, 2019 6:47:32 GMT
Oh, yeah.
They gotta be red. |
|
trois
New Member
Posts: 10
|
Post by trois on Dec 23, 2019 22:37:35 GMT
it works? PO is synchronized with AE?
|
|
|
|
Post by NightMachines on Dec 23, 2019 22:54:42 GMT
it works? PO is synchronized with AE? Yes, AE Modular uses typical analog clock signals so you can sync pretty much anything that accepts or sends analog clock |
|
trois
New Member
Posts: 10
|
Post by trois on Dec 24, 2019 14:42:28 GMT
Great!!!
|
|
|
|
Post by rodney on Dec 28, 2019 17:31:25 GMT
it works? PO is synchronized with AE? Yes, AE Modular uses typical analog clock signals so you can sync pretty much anything that accepts or sends analog clock I am using the AE LFO to send ticks to the Pocket Op. I will try some more rigorous experimentation and report back about using the PO32's clock. Half way through the video is the mighty PO32 drum (a little under-utilised in this instance |
|
